Brodit holder fixed install. Honeywell CT50/CT60 -2A

Price €111.95

Out of stock

Fast Shipping
High Quality Products
Secure Payments

Details

More Information

Compatibility

Instruction

Details

With tilt swivel, with Molex adapter system. 2A charger. An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection). 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Attach onto a Pedestal Mount or an ProClip mounting platform.

More Information

More Information
Accessory brand	Brodit
Barcode	7320285138513
Recommended retail price incl. VAT	€111.95
Device with or without case	without skin
Holder feature	Toestelspecifiek
Cable / Qi / charger type / connnector	Molex, fixed install
Toestel connector	Pogo / Pins
Input Voltage	12/24V geschikt
Voltage (output)	4.6 - 5.3V
Max Amperage	2,0 Amp
Montage standaard	AMPS
Device holder lockable?	no
Color	black
Productinfo	Professional holder with swivel mechanism for your smartdevice. Adjusting holder angle deminishes annoying screen reflection
Product installation	Mount the holder on a ProClip in your vehicle. A detailed installation manual is included in the product packaging
Product suitable for	In the Compatibility tab, check whether your smartdevice is suitable or listed for this holder
Item Returns	This item can be returned

Show more + Show less -

Compatibility

Show more + Show less -

Instruction

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw so the holder is firmly in place, but still can be adjusted.

3. To place the device in the holder: Place the lower part of the device in the bottom of the holder. Flip/Press the top of the device forward into place in the holder. To remove the device from the holder: Place your index finger on the upper part of the holder and push at the same time as you pull the upper part of the device out from the holder. When the device is set free, lift it upward out of the holder.