Brodit Active holder Zebra TC15 cig.plug - 3A fits boot

Price €118.95

In stock

Fast Shipping
High Quality Products
Secure Payments

Details

More Information

Compatibility

Instruction

Details

Active holder with cig-plug

With tilt swivel. 3A charging. 12/24V. With Easy-switching system. Charging via pogo pins. Fits device with Zebra Original Rugged Boot.

The active holder charges your battery when it is in the holder. The charging device connects to the unit automatically when you put the unit in the holder. The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Connects to the vehicle's cigarette lighter socket, 12/24 Volt.

Easy-switching system:

The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

More Information

More Information
Accessory brand	Brodit
Barcode	7320287123555
Recommended retail price incl. VAT	€118.95
Device with or without case	with skin
Holder feature	Toestelspecifiek
Cable / Qi / charger type / connnector	Molex, sig plug, piggy tail (Easy Switching)
Toestel connector	Pogo / Pins
Input Voltage	12/24V geschikt
Voltage (output)	5.4V
Max Amperage	3,0 Amp
Montage standaard	AMPS
Device holder lockable?	no
Color	black
Productinfo	Professional holder with swivel mechanism for your smartdevice. Adjusting holder angle deminishes annoying screen reflection
Item Returns	This item can be returned

Show more + Show less -

Compatibility

Show more + Show less -

Instruction

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.